K and HK cages fit different assemblies
K series cages guide the needles in a radial needle roller and cage assembly. Share the needle diameter, length and count, the cage envelope, and the shaft and housing interfaces. If the shaft and housing act as raceways, identify both surfaces on the assembly drawing.
HK series cages fit inside an open-ended drawn cup. Include the cup drawing or the dimensions at the cage-to-cup interface, including any feature that locates or retains the cage. Matching nominal diameters alone does not establish fit.
Boerjing supplies the molded plastic cage for these projects. Specify the cage as a separate line item from the needles, rings, drawn cup and complete bearing.
HF and HFL differ in bearing support
HF series cages position the locking rollers and guide the spring elements. For review, show the spring and roller interfaces and mark the locking direction as viewed from a specified end.
HFL series designs add bearing support alongside the locking section. In the three-piece plastic arrangement documented by Boerjing, the centre cage guides the locking elements and the two end cages guide the support rollers. Mark the large end, centre and small end on the assembly drawing, then specify which pieces and quantities you need.
Boerjing supplies the plastic cage or plastic cage pieces. Source rollers, springs, outer cups and complete clutches separately. See Schaeffler’s technical overview for the general construction of drawn cup roller clutches.
What to send for a quote
- Part identification Share the full designation and suffix, plus a 2D drawing or 3D file with revision and units, or an approved sample. If you send the assembly drawing, mark the plastic parts to quote.
- Fit and inspection Mark critical dimensions and tolerances, roller pocket size and count, locating faces, mating parts and the intended inspection method.
- Material and duty Specify any required resin grade or restrictions, plus lubricant, operating temperature, speed and duty cycle.
- Quantities and tooling Separate trial and production quantities by piece or set. Note whether tooling is available, the target delivery date and any sample approval requirements.
Material data and quotation terms
Our materials page links to the manufacturer data sheets for BASF Ultramid A3HG5 and Envalior Stanyl TW200F6. Use them to check the resin data. The grade for each cage and its suitability for the application are confirmed during project review.
Custom cages start at 1,000 pieces. Typical lead times are 15 working days without new tooling and 30 with new tooling. The quotation confirms the schedule and start point. On applicable dimensions, ±0.03 mm is achievable after drawing review, which also defines how to measure and accept the part.
The IATF 16949 certificate covers the quality management system for production of plastic bearing cages and bearing polyurethane seals.
Send a project summary through the enquiry form. You can email drawings and 3D files using the address on the contact page.
Request a cage quote